Anest Iwata W101 pressure feed is another Iwata spray gun belonging to the High TEC range which offers extremely high transfer efficiency which can be greater than 65 percent. High transfer efficiencies that rival or even better HVLP transfer efficiency is achievable with the Anest Iwata W101 resulting in savings through lower over spray and less waste. Another huge advantage is the relatively lower compressed air volume requirement for the Anest Iwata W101 pressure feed when compared to typical HVLP spray guns.
The Anest Iwata W101 pressure feed is available in four set-ups starting with a 0.8 millimetre, a 1.0 millimetre, a 1.3 millimetre and a 1.5 millimetre model. The Anest Iwata W101 pressure feed should be operated at three bar inlet air pressure and the two smaller set-ups will consume up to 270 litres per minute of compressed air, while the two larger set-ups will consume slightly less up to 220 litres per minute of compressed air.
Purpose designed pressure feed air spray guns such as these W101 pressure spray gun heads are designed to be use exclusively with paint pressure pots or double diaphragm paint pumps supplying paint at low pressure. If you require a spray gun to be used with a suction pot and on a pressure pot or double diaphragm pump a suction spray gun model from elsewhere within this site.
Anest Iwata W101 pressure feed model part numbers;
- W101082P 0.8mm
- W101102P 1.0mm
- W101132P 1.3mm
- W101152P 1.5mm
